Ford f150 key fob replacement1/23/2024 Locks will again cycle to indicate end of programming mode. Door locks will cycle again to confirm programming. Within 20 seconds, press any button on the second keyless remote. If you only have one remote then skip to step 4.ģ. Door locks will cycle to confirm programming. Within 20 seconds press any button on the first keyless remote to be programmed. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)Ģ. Door locks will cycle to confirm programming mode. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. You are able to program up to four remotes in addition to your remote head keys.ĭo not depress the brake pedal during procedure.ġ. If you are programming additional non-remote head key remotes for your vehicle then they must all be programmed during this procedure. It's not necessary to re-program your working remote head keys as those will continue to work. Obtain all remote transmitters for this vehicle. Remote Portion of Key Fob (Only if the above procedure didn�t program the remote) If the remote portion of the remote did not program but the key will start the vehicle, then please perform the procedure below to program the remote portion of your remote head key If the new key was not successfully programmed, repeat steps 1-4. The theft indicator light will light up for three seconds to indicate the key was successfully programmed. If the new key has been successfully programmed it will start the vehicle and operate the remote keyless entry system. Leave it in the ON position for at least six seconds and turn back to OFF.ĥ. Remove the second key, insert the New (unprogrammed) key before twenty seconds have elapsed and turn to ON. Ignition should stay in ON position for at least three seconds but no more than ten seconds.Ĥ. Remove the existing key and WITHIN TEN SECONDS, insert a second working key and turn to ON and then back to OFF. We are going to reuse the electronic portion that is responsible for. Ignition should stay in ON position for at least three seconds but no more than ten seconds.ģ. Some times it is easier to just replace the broken key shell instead of the entire key. Turn the ignition cylinder ON (Position 3) and back to OFF (Position 1). Insert an existing (working) key into the ignition cylinder.Ģ. If you only have one working key or none at all it must be programmed by a dealer or locksmith.ġ. You Must have Two Working Transponder Keys (keys that start your car) to perform this procedure.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |